There are three groups of patches in this set:ġ. Please review this next set of changes for dunfell and have comments back byĪ few additional notes since this is a large patch set. ` (37 more replies) 0 siblings, 38 replies 39+ messages in threadįrom: Steve Sakoman 19:53 UTC ( / raw) 19:53 ` ffmpeg: Add fix for CVEs Steve Sakoman Note: There are chances, you might see your SD detected with some other devices nodes like /dev/sdc or /dev/mmblk0 etc, so use correct device node which you see in dmesg after connecting SD card, or you might end up formatting something different like your Hard dist.Patch review All of help / color / mirror / Atom feed * Patch review 19:53 Steve Sakoman Now to flash the complete yocto image which normaly contains 2 partitions, we have to use root of sd card partition as /dev/sdb and not /dev/sdb1 Please run fsck.Ībove messages, shows that our SD card is detected as /dev/sdb with only one partition as, /dev/sdb1. FAT-fs (sdb1): Volume was not properly unmounted. sd 7:0:0:0: Attached SCSI removable disk sd 7:0:0:0: Assuming drive cache: write through
sd 7:0:0:0: Attached scsi generic sg2 type 0 scsi 7:0:0:0: Direct-Access MXT-USB Storage Device 1308 PQ: 0 ANSI: 0 CCS usb-storage 2-2:1.0: USB Mass Storage device detected
usb 2-2: New USB device strings: Mfr=1, Product=2, SerialNumber=3 usb 2-2: New USB device found, idVendor=aaaa, idProduct=8816 Now connect SD card to PC, and type dmesg on terminal, you might see messages like below, $ dmesg usb 2-2: new high-speed USB device number 3 using ehci-pci
We need to flash this image to SD card using dd tool as, $ cd build/tmp/deploy/images/raspberrypi3Ĭlear kernel dmesg from terminal to identify latest messages as, $ sudo dmesg -c If you have already followed steps to build root filesystem and kernel for RaspberryPi using yocto as mentioned at “Building kernel and filesystem using Yocto for Raspberry Pi / Creating Embedded Linux for RPi using Yocto”, it creates sdimg files inside build/tmp/deploy/images/raspberrypi3 which contains both RFS & kernel.
0 kommentar(er)
